Patho
Založený: 14.11.2014
Príspevky: 72
Bike: CTM Caliber 1.0
Návod:
Method of use:
1> measured battery should first fully charged.
2> connected with the tested battery anode to cathode to input input positive, negative, is not reversed (with load reverse may damage the circuit)! Connects the load to the output positive electrode and the output negative electrode, through operating power to the tester micro USB (not available on desktop or laptop USB power supply), the display of battery voltage.
3> direct start test only need to press the "OK" button, the tester can automatically set according to the battery full charge voltage suitable termination voltage flicker, and will display 3 times after the start test. Need to set up the termination voltage need only when the battery voltage display state press "+" or "-" key modification, termination voltage display for P at the beginning, behind represents voltage value, resolution 0.1V, set up after the press "OK" to start the test.
4> testing began after the tester will electronic switch connected to the control of the load, the testing process data are displayed in the release capacity (Ah), the current discharge current (A) and a battery voltage (V) between the round. When the battery voltage reaches the set after the termination voltage tester, cut off the load control switch, display the data stays in the capacity (Ah) and the corresponding indicating lamp above and with rapid blinking, the actual discharge capacity of the battery capacity is displayed, press the "OK" can be terminated flashing make stable data display, again by pressing the "OK" the button back to just power on state can replace the battery test the next day......
Podla návodu to funguje, problém je ten vybíjací prúd.
Kice už chápem, I=U/R ďakujem, skúsim teda iný rezistor, len môžeš mi ešte povedať čo znamená W v označení rezistoru?
navigate_next
Ale inac spokojnost.
